Comments on: How to Deploy Multiple Virtual Machines using Network Install (HTTP, FTP and NFS) under KVM Environment – Part 2 https://www.tecmint.com/multiple-virtual-machine-installation-using-network-install-kvm/ Tecmint - Linux Howtos, Tutorials, Guides, News, Tips and Tricks. Fri, 17 Apr 2020 15:54:01 +0000 hourly 1 By: Victor https://www.tecmint.com/multiple-virtual-machine-installation-using-network-install-kvm/comment-page-1/#comment-1328216 Fri, 17 Apr 2020 15:54:01 +0000 http://www.tecmint.com/?p=10977#comment-1328216 Increase Memory on the Virtual Machine to 2Gig and it will work with above guides.

]]> By: mmc https://www.tecmint.com/multiple-virtual-machine-installation-using-network-install-kvm/comment-page-1/#comment-778792 Tue, 10 May 2016 17:58:39 +0000 http://www.tecmint.com/?p=10977#comment-778792 Hi, i am using your instructions here to deploy with FTP/HTTP/NFS – the installation always stalled here:
dracut-initqueue[612]: Warning: Could not boot.
dracut-initqueue[612]: Warning: /dev/root does not exist
Starting Dracut Emergency shell…
Warning: /dev/root does not exist

Generating “/run/initramfs” rdsoreport.txt

Entering emergency mode. Exit the shell to continue.
Type “journalctl” to view system logs.
====
I am using RHEL7 – 3.10.0-123.el7.x86_64
======
output of ‘systemctl status network’ shows issue with “lo” – not sure this affects the issue
[root@vmm ~]# systemctl status network
network.service – LSB: Bring up/down networking
Loaded: loaded (/etc/rc.d/init.d/network)
Active: active (exited) since Tue 2016-05-10 13:33:48 EDT; 21min ago
Process: 1167 ExecStart=/etc/rc.d/init.d/network start (code=exited, status=0/SUCCESS)

May 10 13:33:47 vmm.example.com network[1167]: Bringing up loopback interface: Could not load file ‘/etc/sysconfig/network-scripts/ifcfg-lo’
May 10 13:33:47 vmm.example.com network[1167]: Could not load file ‘/etc/sysconfig/network-scripts/ifcfg-lo’
Thanks in advance of any advice

]]>